Portable Floor
The increased use of multipurpose facilities has created some unique problems for the hardwood flooring professional. Portable flooring systems are frequently dismantled and stored, which presents the opportunity for damage to the finish by marring, scratching, etc. Because of the timeframes involved for screen and recoats, sport floor finishes must develop film properties quickly to […]
Read MoreVOC & Sustainability
Be sure that temperatures of the air, floor and finish are all between 70°F-80°F. As the finish is applied, it will quickly reach the temperature of the floor. A warmer temperature can cause the finish to flash dry and not flow out properly. A cooler temperature can raise the viscosity of the finish, which could […]
Read MoreNever use power scrubbers or automatic floor cleaners
Never use power scrubbers or automatic floor cleaning machines that disperse water on the floor (especially water under pressure). The use of scrubber machines will void the warranty on your floor. Power scrubbers were designed for other surfaces, such as terrazzo and vinyl floors. Even the softest brushes will scratch and dull the finish. The chemicals […]
Read MoreTie Tack
Use the following Tie Tack cleaning systems for periodic deep cleaning, tacking between coats, and to reduce spreading contaminants during screen and recoats. The mixing ratios indicate water to Tie Tack ratio, so 3:1 would imply three parts water to one part Tie Tack. Periodic Cleaning, 3:1 – Mix solution in bucket and clean entire […]
Read MorePolyballs
Polyballs are beads of paint or finish that protrude from cracks in the floor when the moisture content (MC) of the wood rises, causing the cracks to close up. A paint polyball is a serious problem, as it can be smeared over the rest of the floor – potentially requiring screening or even recoating. Polyballs […]
Read MoreScreen and Recoat
Clean the floor with undiluted PoloPlaz Tie Tack. Normal tacking with this solution on a towel is sufficient. However, any concentrated areas of contamination can also be buffed with solution and a white pad – but do not apply excessive liquid on the floor. This cleaning procedure reduces the risk of spreading contaminates throughout the […]
Read MorePanelization and Sidebonding
Sidebonding typically occurs when certain waterborne finishes or sealers flow between the sides of boards and glues them together. When several boards are bonded together they form into one large slab or “panel” of wood. This is referred to as panelization. Panelization has been seen with several types of finishes, but is most prominent with […]
Read MoreDry vs. Cure
Drying occurs when solvents evaporate from the surface of the film, leaving it tack free. There are four important elements of proper drying: temperature, humidity, film thickness and airflow. Temperature affects viscosity, which contributes to film thickness. Humidity affects the evaporation rate of the solvents. The amount of airflow determines how much oxygen will crosslink […]
Read MoreGym Maintenance
Temperature and Humidity Temperature should be kept between 55°F-75°F. Humidity level should be kept between 35%-50% to ensure minimal wood movement. Routine Cleaning Dry mop the floor daily to eliminate dust buildup. As needed, tack floor with PoloPlaz Hardwood Floor Cleaner to remove perspiration, oils, spills and residue from foot traffic. Do not use dust […]
Read More